Tweet
Re: (Quick!) Help w/ A-pillar gauge install
My hookup was far more ghetto. Guess I should have thought of those.
Originally posted by Ryan
-
Pat
Driver Found: Camber Wanted -
Re: (Quick!) Help w/ A-pillar gauge install
You guys aren't actually using those are you?? I'm not trying to be an ass, but 25Gs of a car, and you skimp on the electrical?? It only takes a minute to solder and heat shrink...Originally posted by 1.8TripAs Simon says,
the dimmer switch is the slidey dealy to the left of the turny light switch. There are three wires going to the dimmer switch. Tap into the two outside wires. It really doesn't matter which wire goes to where, because you can just flip the LED around at the gauge. I used some of these quick spice connectors to tap into each wire. Works great and easy to use.
2006 Colorado Xtreme | AEM CAI | Walker exhaust | smoked glass | -1" dropped rear | Avic D3 | 8000K HID's
2002 GTI 1.8t | C1 SS | Upsolute 94 oct | Brullen 2.5" DP | Supersprint catback | Poly mounts | 19" Privat's | FK 55 kit | Projector lights | EVOMS CAI
2000 GSXR750 | Hindle Race exhaust | Telefonica replica | K&N intake | Custom ECUComment
-
Re: (Quick!) Help w/ A-pillar gauge install
meh it works.. if my lighting starts to mess up then i'll whip out the soldering iron..Comment
-
Re: (Quick!) Help w/ A-pillar gauge install
Why? It's not exactly a high performance part where failure meant your vehicle was gonna blow up. It's an LED.Originally posted by TurboMedicComment
-
Re: (Quick!) Help w/ A-pillar gauge install
Thanks to everyone for their help, I'm happy to say the gauge is finally in and works perfectly. Eventhough it took me way longer than expected and a hell of a lot of swearing it is a great mod.
Thanks Again,Bryce
2002 Jetta 1.8T Baltic Green Tiptronic
APR 91, Carbonio CAI, Samco TIH, 2.5" Brullen Turbo-back, ABD Lower Intercooler Pipe, Forge 007 DVComment
Comment