Chassis Dyno?

[VTEC THIS]

I am looking for a place to Dyno my car preferably in the Edmonton or Calgary area. I want to dyno my car this summer since I did a new exhaust, chip, intake, and cams over the winter. Just want to know what kind of power I am putting to the wheels. Anyone know of any places that do chassis dynos? Need names, locations, and phone numbers.

CHEERS!

[Khyron]

Where'd you get the GIAC done and how much?

Khyron

[VTEC THIS]

Denon Performance sent my ECU to AWE Tuning and they did the GIAC. Just call 888-468-0688 and ask for Andy, he'll set it all up.

So what about a chassis dyno?

[Chris]

You can check out Dynomotive here in Calgary (#2, 4120 17th Street SE). Cost is 50 bucks for a baseline pull, 60 for 2 runs, 70 for 3, or 90 bucks an hour. Call (403) 264-3388 or 861-1181 for an appointment. Here's a link to their website -> Dynomotive - it has all this info and more. Hope this helps you out.

C.

[alien]

There's always good old davenport too, don't know what they'll charge though. There's a for more places in Calgary here that has one, can't remember the names though.

[milesmcewing]

Concept one has a chassis dyno up and running, support your VW guys first.
287-8549

Cheers
Miles.

Too bad about World of Wheels, my cars will be there in the Calgary Sports Car Club display.

[VTEC THIS]

Thanks Guys. Keep more names comming if you can think of them. After my car is complete I post Pictures and Dyno numbers for you guys to see. Hope to get down to Calgary this summer to meet up with some of you guys.

CHEERS!

[VTEC THIS]

I believe that you can simulate load on a Mustang Dyno. A Dynojet can not simulate load.

[VTEC THIS]

Well with a Mustang you can simulate load so it can tell you how your car will react on the road. A dynojet is good for comparing baselines to mods but is not a great indication of on the road performance. Look at awe-tuning.com and go to the GIAC chip section. Then look-up interpreting dynomometer info. This should explain it a little better.

CHEERS!