So I installed a battery heater last night and had to disconnect the battery to place it under the battery, reinstalled all the parts and left it over night. This morning fires up fine, the normal lights on the dash are lit up after a battery disconnect i.e. the yellow slip indicator for traction and the little steering wheel which both went off after about 200 meters of driving. The car was running perfect before I installed the heater. Have a code reader from Mac tools which usually shows codes but after about 20km of driving still no codes or anything just no power.
But now i have no power, the turbo doesn't spool up, its as if i am reaching the rev limiter at about 3500 RPM and it wont rev any higher. It won't rev above 3500 driving or just sitting in the garage.
Mods are a turbo back exhaust, REVO chip and cold air.
Has anyone else had the same issue or have any ideas where to start?
Thanks
Andrew
But now i have no power, the turbo doesn't spool up, its as if i am reaching the rev limiter at about 3500 RPM and it wont rev any higher. It won't rev above 3500 driving or just sitting in the garage.
Mods are a turbo back exhaust, REVO chip and cold air.
Has anyone else had the same issue or have any ideas where to start?
Thanks
Andrew
Comment