Tweet
Re: It's Gets Worse Before it Gets Better
It's out of the back seat of a C5 A6, Brent, you can have the other half of the pair I started with, the cup holder is just a bit sticky. I actually took the whole seat from the wrecker as the metal frame from the seat is screwed to the part the cup holders slide into, then the whole thing is covered in foam. The only tricky bit is the defrost vent from the air box up to the dash needs to be modified slightly to allow clearance for the depth of the cup holder. I have pics of that too if you need.
This guy used one from a Lupo, but in my situation, I needed it to come out further to clear the heater controls, thus also being deeper into the dash.
Originally posted by Stonewall
View Post
It's out of the back seat of a C5 A6, Brent, you can have the other half of the pair I started with, the cup holder is just a bit sticky. I actually took the whole seat from the wrecker as the metal frame from the seat is screwed to the part the cup holders slide into, then the whole thing is covered in foam. The only tricky bit is the defrost vent from the air box up to the dash needs to be modified slightly to allow clearance for the depth of the cup holder. I have pics of that too if you need.
This guy used one from a Lupo, but in my situation, I needed it to come out further to clear the heater controls, thus also being deeper into the dash.
I am sure a little heat will form it right up. Could you trim the back of the holder at all?
If it's smoken it ain't broken
Comment