If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Deerfoot from McKnight all the way into airdrie is smooth, and im lowered 2".
Deerfoot southbound from airdrie over the airport bridge is rough, just get as far into the left shoulder and its virtually smooth.
Metis Trail northbound where the construction is, AVOID. Major potholes and just pan death in general.
Stoney trail north from McKnight has alot of dips, i bottom out and rub pretty bad on stoney. Take Deerfoot instead
Deerfoot south to blackfoot (inlcuding blackfoot) all the way to 42nd ave, the two bridges can be rough above 60km/h
lol Colin, what i'm saying is that 1mm is the distance between the 2 lines of an Equals sing ( = ). <-------That right there is 1mm. I'm sure most cars coming off the lot are more than 1mm lower than stock......and I bet they wont smash their oilpans driving along glenmore
Patryk
Instagram: @parkus08
91 BMW 340is ///M-Tech II - Under construction
08 VW .:R32
04 Audi A4 Avant 1.8TQ
Re: PSA - Save your oil pan (Pot Hole Warnings) **GLENMORE**
Glenmore East and West basically under the macleod over pass to blackfoot trail is being repaved with sections of torn up gravel and bridges and regualar road. Theres 4 inch height differences between surfaces and is a hard hit BRUTAL conditions right now and my car isnt even fully slammed and i nailed the first one
EDIT: read every post but colins and this was already said haha
Comment