If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Remember to remove the circlip under the black bearing seal while the transmission is in the horizontal position like it is now. Ryan and i tried for hours with it vertical and the weight of the shaft put too much pressure on the clip.
I got it all apart and back together on Saturday, the repair I did on the 1-2 shift fork though is too large and when I put it back together the 1-2 fork will not move and I cant put the shift tower back in so it will be coming back apart briefly this next weekend.
Got all the seals and snap rings and even an upgrade to get rid of some of the play in the main shaft.
If your having issues putting your selectors back on it sounds like something isn't fully seated. First guess would be something to do with the diff bearings.
Played with it this weekend, ended up flipping the case over and putting the shifter in with the engine side off the case which it was still tricky to get together. It's together now and awaiting the engine.
Comment