Project b6 a4 has a body

[Polishdupa]

Re: Project b6 a4 has a body


This is what I've concluded is the bank one sensor and it is only accessible from the bottom


This is the bank two sensor which i can get from the top but not the right one thats throwing the code

[PRY4SNO]

Re: Project b6 a4 has a body

At least there's more room in the B6 engine bay compared to the B5 for when you stuff your built 2.7t in there.

[Polishdupa]

Re: Project b6 a4 has a body

Good point but it's seems like the easiest way to get to it would be to Pull the engine

[PRY4SNO]

Re: Project b6 a4 has a body

Try a ratcheting open ended wrench maybe. Save yourself the effort if you can...

[Polishdupa]

Re: Project b6 a4 has a body

Just took the Car off insurance and left it on parking so I'm waiting for mine 2.7 liter short block to be done and I'll start the swap

[Polishdupa]

Re: Project b6 a4 has a body

haven't done anything for the past week but this is my plan of attack

[PRY4SNO]

Re: Project b6 a4 has a body

Gave up and going fishing Marco?

[Polishdupa]

Re: Project b6 a4 has a body

haha no went hunting


maybe today i'll get that it out

[The_Jerbel]

Re: Project b6 a4 has a body

You get anything? That's a nice Tikka. Bushy 4200 4-16? What is that bipod? Haven't seen that one before. What cartridge is it chambered in?

[Polishdupa]

Re: Project b6 a4 has a body

The bi pod is a custom made one tikka t3 308 with a muzzle break on it. topped off with the bush 4200 elite.
No didn't see what we were hunting did run into a mama bear with two cubs at about 100yards and lots of wolf tracks but no elk or deer. I think the winter must have killed alot off

[Polishdupa]

Re: Project b6 a4 has a body

Soooooo..... I did some work tracing the sensor wire straight from the exhaust and found exactly what plug it goes into. Then today I got my B6 Audi ebahn and found it in 5 minutes

[Polishdupa]

Re: Project b6 a4 has a body

Now i realized the 02 sensor I have is for after the cat, have to find a new one and hopefully have it by the weekend...
Hint Hint

[sabbySC]

Re: Project b6 a4 has a body

I've got a used bosch sensor, if it works to get you through a pinch you are free to use it. It works for a 1.8t and a 2.0, if the harness connector is the same, I bet it would work fine. It was in perfect working condition, I just swapped it because I had to do some data logging and wanted to ensure I had a new sensor.

[Polishdupa]

Re: Project b6 a4 has a body

that would be great is it the 6 pin sensor? and if so i'll pay for shipping

[sabbySC]

Re: Project b6 a4 has a body

Didn't realize you are in edmonton, it is a 6 pin conector, provided it is the same connector you could go to napa and get a NTK 24317, that is a cheaper replacement O2 sensor that is the same and should be in stock.

I think the cost of shipping it to you one day would probably be pretty close to the cost of a new sensor, but if you want I can do it. I'd send you a pick of the connector first though, give me a couple minutes here and I'll get one and send it to you. I can tell you if it is the same connector that the 24317 is the same part with a longer harness and otherwise no difference.