Base line # dyno for 2011 1M vid

[Speed Cat]

http://www.youtube.com/watch?v=FRKrp...layer_embedded

For stock this looks good... I have Dinan S2 for my 1er, and To the wheel im about 350HP give or take from what has been reported with the same set up

[PRY4SNO]

Re: Base line # dyno for 2011 1M vid

Nice! How much torque? It would be cool to see a graph too.

[Speed Cat]

Re: Base line # dyno for 2011 1M vid

http://www.bimmerpost.com/forums/att...8&d=1306380924


Graph Torque is at 362

[Speed Cat]

Re: Base line # dyno for 2011 1M vid

Edmunds dyno'd the 135i at

285hp @ 5740
291lb-tq @ 3100

[QuA]

Re: Base line # dyno for 2011 1M vid

Those are impressive #'s. I thought it was bang on, but then saw it was to the wheels "eeeek"! Very nice.

Just got back from BMW, extended my warranty to 3 yrs extra Going to keep it for a while now.

Speedcat we should go for a dyno and compare Dinan vs Juicebox ^_^

[R-Audi]

Re: Base line # dyno for 2011 1M vid

Comparing all these dynos is kinda useless...You could take your 135's to any of the dynos around Calgary and you will not get the same readings at any two; WAY to many factors to consider.

[bart]

Re: Base line # dyno for 2011 1M vid

basically a 1M won't chip higher than a 135i anyway right?

[R_Ethug]

Re: Base line # dyno for 2011 1M vid

thats my thinking.. maybe i'm wrong

[Speed Cat]

Re: Base line # dyno for 2011 1M vid

From What i have been told and read, The internals of the N54 Engine in the 1M have been changed to with stand higher Temps and what not.. SO you never know... My thoughts are however, it will chip higher, but i don't think it will be that much more...

Even if it is the same the M1 will still be way better putting the power to the ground...

[bart]

Re: Base line # dyno for 2011 1M vid

but are the turbos the same...?

[Speed Cat]

Re: Base line # dyno for 2011 1M vid

but are the turbos the same...?

Not sure...

[QuA]

Re: Base line # dyno for 2011 1M vid

Comparing all these dynos is kinda useless...You could take your 135's to any of the dynos around Calgary and you will not get the same readings at any two; WAY to many factors to consider.

I agree, however you would have to start at some location and get some sort of baseline and see what the supporting mods would do after. I thought insideline performed all dynos at the same location.

The 1M must have a different tune, likely the same as the z435is.

[Speed Cat]

Re: Base line # dyno for 2011 1M vid

Found this

1 Series M coupe plus a little more
-----------------------------------

The BMW M Gmbh builds on the legendary BMW M3 and puts on a real M-version of the 1 Series (E82).
And we shall go one better - on the street, but also on the racetrack.
Internal preparations for it are in full swing and soon we will be fully informed of these crunchy athletes "made by Dahler" with 408 HP and 540 Nm.
The tension grows.

Source: http://www.daehler.com